Installing the Wetted Boot Dip Pan Enhancement

1. Unpack the Enhancement for the EVO One per the instructions on the box.
2. Attached the two supplied clear hoses onto the fittings on the rear of the pan. These hoses push onto the fittings. Do not hard pipe to these fittings for future cleanability and maintenance. They are to divert the water from the pan to your required floor drain. If additional hose length is needed, contact Meritech Support Team.
3. Place the boot dip pan in front of the EVO One station, making sure that the pan is centered to the system and sitting level and does not rock. See drawing on page 19 of this manual.
4. Once the pan is in place, ensure the 2 drain hoses are directed towards the floor drain and that they are flat to prevent the pan from overflowing.
5. Press the unlock button on the touch screen and enter your customer pin number.
6. Once in the main menu, prime the pan by pressing the "Prime Pan" button shown in the photo. The pan will begin to fill, if additional fluid is desired, press the "Prime Pan" button again till the desire level is achieved.