- View All Lessons
Before You Start
Install Your Equipment
Enhancements Install
Additional Support
Controlled Access Turnstile
Installing the Controlled Access Turnstile
1. Unpack the Enhancement for the EVO One per the instructions on the box
2. Do not plug in the system or turnstile power cords until wiring is complete
3. Complete instructions for the controlled access turnstile can be found in the manufacturer's manual
4. Assemble the handwasher/turnstile. This can be configured as either right or left-hand
5. While the top cover and front cover on the turnstile are removed for installation Install the conduit into the right or left side of the turnstile
6. Run the power cord and control cable up the right or left/rear side of the turnstile. Secure in place with supplied tie wraps Install the turnstile power cord wires per the photo (Black = Load White = Neutral Green = Ground with Yellow wire nut)
7. Install the control cable to the control module (Red= 24 VDC + Black = l1 or l2)
8. Once wiring is complete, verify no AC or Control Cable wires interfere with moving parts of turnstile. Tie up wires with wire ties