Follow the instructions below to install your Sole Clean footwear sanitizing pan:

Setup

1. Place the pan in front of the 2000S
2. Place Sole-Clean cart to the right or left of the hand washer per the photo below
   
3. Make certain that the pan is sitting level and does not rock.
4. Place the three mats into the pan, ensuring that they are in the correct order from bottom to top:
   1. black bubble mat
   2. grey absorptive mat (with soft side up)
   3. red foot placement mat (with grip knobs upward).
      
5. Place the Sanifect D2 Sanitizer bottle into the basket attached to the Sole-Clean cart.

Connect

1. Connect the pickup tube cap to the sanitizer bottle. (it is attached with a clear tube just above the tube going to the pan)
2. Connect the yellow cable coming out the back of the hand washer to the electrical connection on the front of the Sole-Clean stand.
3. Take the 3/8” sanitizer supply line and connect it to the fitting on the bottom of the Sole-Clean system. Make certain the supply line is pushed at least 3/8” into the fitting.
   
4. Route the other end of the supply line under the hand washer and attach it to the pan manifold.
   
   
5. Push the pan under the system making sure the two tabs are between the legs of the hand washer.

Great work, you're done! If you have additional enhancements click below for install instructions