Station Setup Screens

The CleanTech® EVO station has been designed to be intuitive for users to both use and setup. Over this next section we'll dive into how the touchscreen display on an EVO station works during the setup process. Please note: touch the screen with a firm touch, the screen was designed to be durable so it will not respond to a light touch. For additional help using the display, please contact the Meritech support team at support@meritech.com or 1 (800) 932-7707.

Welcome Screen

The initial welcome screen will begin walking you through setting up your CleanTech EVO Station. This welcome screen will appear every time the system is powered on. If the station has been previously setup, use the "skip" button to bypass this process.

Setting up the Wi-Fi Connection

Connecting the system to Wi-Fi will allow Meritech to monitor the health of the station and assist with trouble-shooting and updating software. Additionally, connecting to Wi-Fi will allow the compliance data that is generated from the system be available to you on the App (under development). No data is shared with any other source than Meritech and no personal information or identification is collected or shared. If the "Yes" button is selected and you choose to connect the station to Wi-Fi, you will be guided through entering your Wi-Fi Network credentials. If the "No" button is selected, please note that limited service and diagnostics may be limited. Additionally, time & date will have to be set manually, see page 31 to set the date and time in the system.

Configuring the Auto Warm Up Cycle Schedule

Configuring the Auto Warm Up Cycle will allow you to customize the specific days and times that the handwashing station needs to be at the optimum temperatures of 100-105° F for your staff. Once set, the station will automatically turn on get the handwashing station to parameters set.

We recommend a water temperature range of 100– 105° F as it provides the most comfortable hand wash to promote the highest levels of handwashing compliance among your team. Temperatures that are too cold provide an uncomfortable handwashing experience and reduce compliance levels. The system will NEVER scald employee hands. We have several safeguards in place including an automatic shutdown should the water temperature reach above 110° F to prevent any injury to staff while using the station.

Facility Drain and Water Connections Confirmation

The next 3 screens walk you through verifying the facility drain, hot & cold lines are connected and turned on. For step-by-step instructions please see page 12 of this manual that review these install instructions. Should you have any difficulty with these drain or water connections, please contact the Meritech support team.

Setting-up Hygiene Solutions Screens

These next screens will walk you through the installing the hygiene solution cartridge(s) into your station. The system will not run unless a UP X solution cartridge is installed into the station. On the EVO Wall, the self-cleaning functionality of the station is a CleanTech® Enhancement. For additional information please contact the Meritech sales team at support@meritech.com or 1(800) 932-7707.

Priming the CleanTech® Station

After the solutions have been installed, the system is now ready to be primed. Priming mode will fill the solutions lines with the UPX or SelfCleanX solutions so that the very first handwash is prepared for the first user. The next 3 steps prime the solutions in the solution and put the system in Run mode. The handwashing station is ready for use.