- View All Lessons
Before You Start
Install Your Equipment
Additional Support
Install solution
Follow the instructions to install the solution in your MBW:
Follow the steps below for installing the solutions container and priming the system.
- Remove cap and pick-up tube attached to the bottle of Meritech Boot Cleaner.
- Place the new container of Meritech Boot Cleaner in the basket.
- Drop the pick-up tube in the new container and screw on the container lid.
- Hold your hand over one of the systems photoeye’s at the drain end of the system which is the priming photoeye’s until the system begins to run water and consume soap.
- Continue covering the Photoeye until the Boot Cleaner fluid is fully primed in the system & the green LED light is flashing and the brushes are rotating.