Install your CleanTech® 2000S

Learn about facility requirements, how to mount and hook up your equipment, and view the equipment manual.

Boot Dip enhancement install

For this install you will need:

  1. Unpack the boot pan and place in front of the 2000S per the photo below.

    Screen Shot 2022-02-23 at 11.51.09 AM
  2. Make certain that the pan is sitting level and does not rock.
  3. Pull the pan away from the system and attach the two drain hoses, one to each of the ¾” male pipe threads on the back of the pan drain box. See photos below
    Screen Shot 2022-02-23 at 11.51.20 AM
  4. Take the water supply line and connect to the fitting on the bottom left side of the system. See photo below. Make certain the supply line is pushed at lease 3/8” – ½’ in to the fitting.
    Screen Shot 2022-02-23 at 11.51.27 AM
  5. Take the opposite end of the supply line and attach it to the pan manifold. See photo below.
    Screen Shot 2022-02-23 at 11.51.36 AM
  6. Push the Boot Sanitizing Pan into the system, making certain the 2 tabs are on the inside legs of the CleanTech 2000S system.
  7. Once pan is in place make certain the 2 drain hoses are directed towards the floor drain, and that they are flat to prevent the pan from overflowing.
    Screen Shot 2022-02-23 at 11.51.45 AM

Great work, you're done! If you have additional enhancments click below for install instructions

Lesson Links