Get Started With Boot Scrubbers 

Learn how to use your equipment, train employees, receive support, audit with Meritech boot scrubbers, and more!

How to install solutions

Installing Solutions & Priming System

When the Red LED indicator light is flashing and the system alarm is sounding the solutions container needs to be replaced on the system. Follow the steps below for installing the solutions container and priming the system.

  1. Remove cap and pick-up tube attached to the bottle of Meritech Boot Cleaner.
  2. Replace the empty container with a new container of Meritech Boot Cleaner.
  3. Drop the pick-up tube in the new container and screw on the container lid.
  4. Hold your hand over one of the systems photoeye’s at the drain end of the system which is the priming photoeye’s until the system begins to run water and consume soap.
  5. Continue covering the Photoeye until the Boot Cleaner fluid is fully primed in the system & the green LED light is flashing and the brushes are rotating.