- View All Lessons
Before You Start
Install Your Equipment
Enhancements Install
Additional Support
Connect your CleanTech® Station
Installation of your CleanTech® 4000S is really just three simple steps:
1. Hook up the Drain
Attach the drain boot to the drain tube. After the boot is tightened, tug on the drain to ensure it is secure.
2. Attach the Water Hoses
Connect the hot and cold water hoses. We recommend you use the hoses supplied by Meritech to ensure that you have adequate hot and cold water flowing to the system. This is important for water flow and to ensure a comfortable temperature for users.
3. Plug in the CleanTech® Station
Plugin the CleanTech® Automated Handwashing Station. Run a couple of cycles to check for leaks from the hoses.
After verifying there arent any leaks we can move on to installing the solution and you will be good to go!