Follow the instructions to install the solution in your XBW:

Follow the steps below for installing the solutions container and priming the system.

1. Remove cap and pick-up tube attached to the bottle of Meritech Boot Cleaner.
2. Place the new container of Meritech Boot Cleaner in the basket.
3. Drop the pick-up tube in the new container and screw on the container lid.
4. Hold your hand over one of the systems photoeye’s at the drain end of the system which is the priming photoeye’s until the system begins to run water and consume soap.
5. Continue covering the Photoeye until the Boot Cleaner fluid is fully primed in the system & the green LED light is flashing and the brushes are rotating.

Congrats!! Your boot scrubber is ready to use.